OZ9AEC

 
  • Increase font size
  • Default font size
  • Decrease font size
Home

Funcube Dongle with Quisk SDR

Print PDF

Today I have spent some time trying the Funcube Dongle with Quisk SDR. The setup procedure was quite painless and the results very satisfactory: Using an Arrow II hand-held yagi connected directly to the FCD I could receive the HO-68 CW beacon with very good SNR.

For this experiment I was using Ubuntu Linux 10.10 64 bit.

By default quisk uses the default sound card as input device. To use the Funcube Dongle as input, first check its device number:

  $ cat /proc/asound/cards 
0 [ICH6           ]: ICH4 - Intel ICH6
Intel ICH6 with AD1981B at irq 21
1 [default        ]: USB-Audio - FUNcube Dongle V1.0  
Hanlincrest Ltd.          FUNcube Dongle V1.0   at usb-0000:00:1d.3-2,

In ALSA language the funcube Dongle is hw:1 on this computer (the built-in Intel device is hw:0). Now create a copy of quisk_conf_model.py – call it quisk_fcd.py and edit the contents:

  sample_rate = 96000               # ADC hardware sample rate in Hertz
name_of_sound_capt = "hw:1"       # Name of soundcard capture hardware device.
name_of_sound_play = "default"    # Use the same device for play back
channel_i = 0                     # Soundcard index of in-phase channel:  0, 1, 2, ...
channel_q = 1                     # Soundcard index of quadrature channel:  0, 1, 2, ...

Now we can start quisk:

  $ ./quisk.py -c ./quisk_fcd.py

First thing I noticed was that the qthid application was crashing whenever I tried to use it together with quisk. This stopped happening after I updated the HID files as suggested by Pascal Hirsch in this message. I copied the latest version of hid-libusb.c and hidapi.h into the qthid folder and changed the hid002.pro file by appending:

linux-g++: INCLUDEPATH += /usr/include/libusb-1.0

Now I could use qthid and quisk at the same time. I have let them run for about an hour before HO-68 had AOS.

HO-68 satellite pass

It was too cold to go outside so I stayed indoors and pointed the Arrow out through the window facing South. However, I could hear the CW beacon already though the walls before the satellite came to the South side. The signal was very strong during the peak, which was about 52° El, range 1400 km. According to the Amsat website, the HO-68 CW beacon transmits with 200 mW.

The video below shows a recording from the second half of the pass while the satellite is receding.

Watch the video on YouTube.